Modify IP for Eyelink on PC

This instruction is for PC systems.  (Mac systems see the main page for Eyelink installation)

  • Go here Start menu > Control Panel > Network and Internet Connections > Network and Sharing Center

  • In the following Screen, choose “Change adapter settings” icon on the left side panel (see Figure below).

  • Check the list of installed components to make sure a network card is detected. If not, install the driver for the network card.

  • Double click on the network card icon that represents the network card that will be connected to the EyeLink 1000 Plus Host PC.

  • Select the “Properties” button.

  • Select the “Internet Protocol Version 4 (TCP/IPv4)” and then click on the “Properties” button (see Figure below). Select the “Use the following IP address” radio button. Enter the IP address of " ”. The last digit of the IP address can increase for other computers on the EyeLink network. Enter the subnet mask of “ ”. Leave the default gateway and other settings blank (see Figure below).

  • Click on “OK” to return to the Properties dialog. Click “OK” again to save your changes. Click “Close” to exit from the network card dialog.